Folded Star Ornament - Finishing Steps

Finishing Both Sides

I finished pinning on the second side of my folded star ornament. I decided on the second side I would only place 3 layers of fabric. However, I started the center in green this time. So, when I was finished, both sides met with the green fabric. Here are photos of both finished sides.



Where the sides meet is where you will place your fabric strip or ribbon. Most times, my sides don't match up perfectly. But like I referenced previously, who cares. It's going to be covered up with fabric anyway. I just make my fabric strip a little wider to make sure I cover it all. Here are my sides. See how at one spot, they overlap a little and in another, there's a nice gap.






Finishing the Ornament


Wrap a string or measuring tape around your ornament to determine the size of ribbon or fabric you need. For this size foam ball, I'll need a 10" strip to be exact. However, I like to add a couple inches to that in case I have any issues and to make a tube at the top to act as a hanger. I usually use matching fabric (or contrasting, depends on the mood :-) 2" wide strip.


Then I fold the strip in half, right sides together and stitch a 1/4" seam down it to make an inside out tube. Turn the tube right side out and press with the seam on the inside, bottom center of the strip. I end up with a 3/4" finished strip to wrap around the ornament.



  • Optional instructions - Just fold the sides in (1/4" each) to the back center and iron to make a 1.5" strip with sides folded under. Then, fold this in half again to form the 3/4" strip. This hides the raw edges and still gives you the 3/4" strip to wrap around the ornament.

I cut the finished strip to 10" (or however long you need) and then from the excess piece I cut a 1" piece which I'll use later. On the 10" strip, I add double stick tape. Then carefully thread the one end through the 1" piece and secure with tape on the underside. This will be the hanger at the top of the ornament.


Place the area with the 1" piece on top of your ornament if you have a preferential "top". Wrap the piece around your ornament and secure. When you come to the top, feed the other end of the wrap into the 1" piece on the top of your ornament. I'll even reach in with a pin inside this piece and secure further. Now, your ornament is ready for hanging.



  • Optional instructions - just use the 10" strip and tape it to the ornament letting the ends meet at the top. Glue on a piece of fabric on top to cover the joint of the two ends where they meet at the top. Adhere something to hang the ornament.Here's the finished wrap. I like using fabric because the wrap is then very smooth.

Hang on your tree or give as a gift! Please let me know if you have any questions.

Thanks for stopping by!

~*~Trish~*~

No comments:

Post a Comment